Jobs Board Plumbing Jobs in Kyneton Plumbing Jobs in Kyneton

I would like to have a bathroom renovated....it is a very tiny bathroom upstairs in a very old (1860) building. Needs to be waterproofed, new vanity, bath removed, shower installed, new toilet.... I would like to have a bathroom renovated....it is a very tiny bathroom upstairs in a very old (1860) building. Needs to be waterproofed, new vanity, bath removed, shower installed, new toilet. Window covered up and new window installed.

I'm looking for someone to do the plumbing for a house that we are renovating. This will involve setting up a new Rinnai infinity hot water system, plumbing in a bathroom and laundry (toilet,... I'm looking for someone to do the plumbing for a house that we are renovating. This will involve setting up a new Rinnai infinity hot water system, plumbing in a bathroom and laundry (toilet, shower, bath, basin) (new pipes will be required as we are transforming another room into a laundry and bathroom), plumbing kitchen and removing old pipes and existing hot water system. A plan of the house can be found here - http://dl.tagell.com/image/2M0U1q3V233s . We are still planning so things might change a little bit, but not much.

showerbase is cracked which I believe is ceramic it does not appear to be leaking but there is some movement as there is fine powder outside the shower where the crack is showerbase is cracked which I believe is ceramic it does not appear to be leaking but there is some movement as there is fine powder outside the shower where the crack is

Wood heater to be installed in to existing house requested plumber (ultimate ) Wood heater to be installed in to existing house requested plumber (ultimate )

Singe storey house and separate garage needing new gutters, fascia, some downpipes and looking for installation of two water tanks. Singe storey house and separate garage needing new gutters, fascia, some downpipes and looking for installation of two water tanks.

Install 2nd hand (10 years old) caroma toilet pan & dual flush cistern suite with rear outlet 185mm high. the cistern rests on the top back of the pan with screws into the wall as well. new... Install 2nd hand (10 years old) caroma toilet pan & dual flush cistern suite with rear outlet 185mm high. the cistern rests on the top back of the pan with screws into the wall as well. new rear outlet height 185mm is not quite the same as the old one (was 200mm) so the 4" collar assembly that rotates for that height difference will need to be removed and replaced. mains connection to cistern, currently about 400mm 1/2" copper pipe to old cistern bottom, will end up being a very short length to the inlet of the new one, maybe less than 50mm. joining up will be a bit fiddly. i will need to repair the floor there at some stage but am okay to remove and replace the unit once it fits.

carpenter has cut a plastic pipe vent needs to be taken out&replaced&is under the house access ok single story&customer will give provider a hand with the work carpenter has cut a plastic pipe vent needs to be taken out&replaced&is under the house access ok single story&customer will give provider a hand with the work

GAS SYSTEM- BELIEVED TO BE PILOT LIGHT RELATED GAS SYSTEM- BELIEVED TO BE PILOT LIGHT RELATED