Bends put in two existing downpipes

Murray requested 3 quotes from Plumbers in Belmont

  I have two downpipes that run at a slight angle down from the gutter to the drain in the ground. I would like some bends or joints added to both so that they no-longer descend at a slight angle but straight down and flush with the pole that they run next to. Joints or bends would be needed to be added to the bottom of the two downpipes so that they are still connected to the in-ground drain. The downpipes are both attached to an awning on a single level house

Quote Details

  • Suburb Belmont, VIC 3216
  • Specialisation General Maintenance Plumbing
  • Date Listed 5 Jun 2017 - 12:39 pm

Similar Quote Requests

Repair/replace flick mixer tap in kitchen
Flix mixer tap in the kitchen to be repair or replace- plumber

FIX A LEAK IN THE SHOWER, THERE IS A LEAK IN THE PIPES
FIX A LEAK IN THE SHOWER, THERE IS A LEAK IN THE PIPES

PLUMBER TO BLOCK OF GAS PIPE TO OVEN
PLUMBER TO BLOCK OF GAS PIPE TO OVEN. AND ADJUST PIPES WHERE NEW KITCHEN SINK...

Gas heater needs to be serviced and a toilet cistern that needs to repaired
My Gas Glow heater needs to be serviced as the pilot light will not stay lit....