Plastering Quotes
from local plasterers
Put back block on the ceiling joints and retap, plaster and sand cracks
Liying requested 2 quotes from Plasterers in Brookfield
temporarily brush away the cellulose fibre insulation located directly above the ceiling joints, ensuring the plasterboard surface is clean. Install 200 mm wide plasterboard back blocking loosely fitted between framing members to all ceiling joint for upstairs living room. The back blocks must be adhered using a plaser-based setting type adhesive/cement which then must be applied to the full face of the back block with a notching spreader to give 6 mm by 6 mm beads at approximately 20 mm centres. Note flexible adhesives must not be used. After the back blocking has dried and is secure, reinstate the cellulose fibre insulation; Remove access plaster/setting material from the existing ceiling joints and retape and reset joints to achieve a finish of no less than a level 4.
Plasterers that Responded
B & P Plasterers
Quote Details
- Suburb Brookfield, QLD 4069
- Specialisation Dry Wall
- Date Listed 29 Jul 2008 - 5:59 pm
Similar Quote Requests
To set billaboard on deck, setting joints and screws also
Setting joints and screws in billboard on ceilling of outside deck
357sqm d/story house to be replasted 10 rooms
D/story down stairs is 2b plastered and set with cornice.upstairs is square...
Ceiling,2 walls and patch ups, light fixtures to be plastered
ceiling,2 walls and patch ups, light fixtures to be plastered
Need a wall (internal) wall repaired where there is a large crack
I have a large crack (just under a metre) in the wall of which the wall may...
Plastering Quotes
from local plasterers
