Disconnect Power, replace fascia, secure mains into home

Rob requested 3 quotes from Electricians in Chatswood

  Scope:
Re-secure the electrical power pole that holds the electrical supply cable from the street.
Currently the electrical support post is bolted to the fascia board. The fascia board and its supporting rafter brackets are rotting and need to be replaced.
Will require Electrician with Level 2 license. i.e disconnect cable to street supply.

Details:
Disconnect the street electrical supply to property.
Remove fascia board. Note that the gutter has already been disconnected at the corners and will easily come off with the fascia board.
Cut out and replace three (x3) rotten rafter beams that the fascia is attached to.
Install supporting brackets for electrical pole in the same location as original pole.
Reconnect electrical metal pole to fascia, and bolt to new brackets.
Re-use the supply power cables into the building.
Close up the eve with cement fibre board (screw in).
Reconnect Electricity.
Work would ideally be done within a 1 x day so electricity can be restored.

Dimensions of Wood Work
Fascia Board Dimensions
Length: 5mtr (5000mm)
Height: 220mm
Width: 20mm

Rafter Beams Dimensions. 4x2inch
Quantity (QTY): x 3
Length: Approximately 500mm (50cm)
Height: 95mm (4inch)

Pictures can be emailed and can meet you at site to discuss.

Electricians that Responded

GEM Electricians

GEM Electricians “The right choice, the safe choice!”

The initial response to the job was quick but the time to get in touch with the right person took about a week. Overall Joe was helpful and I was satisfied with his proposal. Unfortunately in the end we did go ahead with the job.

H4ORCE Electrical PTY LTD

H4ORCE was quick to respond to the job. He called up about the job to confirm details. He also followed up a couple of times to check if we intended on going ahead with the job. He was professional and his quote was reasonable. Unfortunately we did not go ahead with the job.

Quote Details

  • Suburb Chatswood, NSW 2067
  • Specialisation General Electrical
  • Date Listed 14 Oct 2015 - 7:40 am

Similar Quote Requests

Bathroom reno electrical prep for Friday 15 Feb
Electrician- 1st visit 1. Uninstall existing lights- 1 x ceiling light...

Install 3 ceiling fans, 2 with lights
Installing 3 ceiling fans, 2 of them with lights into 3 bedrooms. For 2...

Replace 7 lighting fixture
I have 7 lighting fixtures I'd like replaced

Install video cameras
I have four video cameras to be installed in a unit block; front, back, front...