Door Professionals
Jobs for Doors - Automatic Doors
Located at dural, sydney 2158.
Service Central searched for quality
door professionals in Sydney
for Finbarr.
Post your door job
Remote for auto roller dooe not operating properly.
Service Central searched for quality
door professionals in Melbourne
for Tan.
Post your door job
We currently have a manually operated panel type garage door and would like to make it automatic. We need someone to supply and install the automatic opening device.
Service Central searched for quality
door professionals in Melbourne
for Stuart.
Post your door job
The sliding doors to our shop keep getting stuck open it looks like the sensor is not working properly.
Service Central searched for quality
door professionals in Brisbane
for Martin.
Post your door job
We are searching for a company to supply and install automated entry system using "FOB" or "CARD READERS". This is to be installed to a building that provides volunteer rescue. We have approx. 50 members whom need to have access to this building.
Service Central searched for quality
door professionals in Melbourne
for Stewart.
Post your door job
When remote controller (or the main controller) is pressed to close the door, the door comes down but then it goes up again.
Opeining the door is not a problem but problem with closing.
Service Central searched for quality
door professionals in Sydney
for Peter.
Post your door job
Glass Revolving door needs service.
Service Central searched for quality
door professionals in Melbourne
for Khaled.
Post your door job
Doors do not close properly. Keep getting stuck open.
Ipswich job.
Service Central searched for quality
door professionals in Brisbane
for Amy.
Post your door job
Jun 06: In Beaconsfield, Melbourne, VIC
Auto garage door pulley need to be reattached on one side of door
I would like this to be done as soon as possible as the door is not fully closed and thnere is a security risk.
Service Central searched for quality
door professionals in Melbourne
for Nicky.
Post your door job
3 roller doors with merlin motors. One door slightly out of alignment.
Service Central searched for quality
door professionals in Regional New South Wales
for Richard.
Post your door job
My GDO-4 Easy roller automatic garage door stopped work last week ,when I use the remote control I can saw the light of drive unit is on , but the door could not open and close ,then I changed a new battery but the door keeps still .
Service Central searched for quality
door professionals in Melbourne
for Yi.
Post your door job
I have a faulty motor on my roll a door, it needs to repaired / replaced.
I have a picture of the motor if required.
I used to install these doors a long time ago so I am pretty sure I can fit the new / repaired motor myself.
I was washing the floor in the garage and from inspection from my local dealer, the motor got wet, I am not totally convinced that this is what happened but apparently I need the motor repaired or replaced . When I powered the control-A-Door with a known good power point, it failed to operate.
Service Central searched for quality
door professionals in Regional New South Wales
for Scott.
Post your door job
Auto door for slug. Not replacing the existing door. Just install a motor.
Service Central searched for quality
door professionals in Sydney
for Yvonne.
Post your door job
We have an ATA Secure Lift auto garage door model number GDO2V6. The sprocket has broken off and now the chain will no longer connect up.
Service Central searched for quality
door professionals in Sydney
for Ruth.
Post your door job
We have a single roller door on our garage which we would like to get motorised. There isn't much space on each side of door - approx 125mm only.
We are ready to go now, or are happy to wait until the right person is available.
Service Central searched for quality
door professionals in Sydney
for Amanda.
Post your door job

